高级氧化技术强化皮革废水生化处理效果初探

皮革废水中含大量难降解有机物,导致常规好氧生化处理速率低、效果差.实验考察了在Us(超声波)、UV(紫外光)、US/Fenton、UV/Fenton等高级氧化技术强化作用下的生化处理效果,结果表明,在相同水质和实验条件下,废水经Us、UV处理30min后可使后续生化反应速率显著提高,分别反应8h、24h后的COD去除率即可达到直接经微生物处理48h后达到的48%,但延长反应时间至48h对COD去除率没有明显提高;Fenton试剂强化US、UV的处理效果要高于单独Us、UV工艺,经30min预处理,随后在微生物作用下分别反应4h和8h即可达到45%和51%的COD去除率,同时延长反应时间也能使最终COD去除率明显提高,反应48h后,COD去除率可分别提高至64%和72%.     

Synergistic effect of F and triggered oxygen vacancies over F-TiO2 on enhancing NO ozonation

Oxidation-absorption technology is a key step for NO_x removal from low-temperature gas. Under the condition of low O₃ concentration (O₃/NO molar ratio = 0.6), F-TiO₂ (F-TiO₂), which is cheap and environmentally friendly, has been prepared as ozonation catalysts for NO oxidation. Catalytic activity tests performed at 120°C showed that the NO oxidation efficiency of F-TiO₂ samples was higher than that of TiO₂ (about 43.7%), and the NO oxidation efficiency of F-TiO₂-0.15 was the highest, which was 65.3%. Combined with physicochemical characteristics of catalysts and the analysis of active species, it was found that there was a synergistic effect between F sites and oxygen vacancies on F-TiO₂, which could accelerate the transformation of monomolecular O₃ into multi-molecule singlet oxygen (¹O₂), thus promoting the selective oxidation of NO to NO₂. The oxidation reaction of NO on F-TiO₂-0.15 follows the Eley-Rideal mechanism, that is, gaseous NO reacts with adsorbed O₃ and finally form NO₂.     

腕足类生物壳体在沉积、成岩过程中同位素平衡问题研究

综合分析了现代腕足类生物壳体方解石中的C、O同位素特征，以及有关古生代腕足类生物壳体方解石构造和地球化学研究成果，分析结果证明：只有那些无发光性特点、无胶结和溶蚀构造特点、有较好纤维构造特点、含高Sr、Na和低Mn、Fe（Mg）的第二层腕足类生物壳体方解石的δ18O值不受成岩作用影响；而原始层和壳体中的特殊部位如铰合轴、腕骨、茎孔、交互面、肌痕等在沉积、成岩过程中与海水处于非同位素平衡状态。     

A／O工艺处理石油化工废水试验研究

本文介绍了采用Ａ／Ｏ新工艺组合处理高浓度的炼油、化工混合废水中试情况，试验结果表明；Ａ／Ｏ新工艺组合具有抗冲击性能好，产泥量少，在一定条件下，出水各项指标达标排放，还就填料选择、含氮化合物的消化反应、污泥生物相和各池工艺参数相互关系进行了讨论。     

Insights into reactive oxygen species formation induced by water-soluble organic compounds and transition metals using spectroscopic method

Ambient particulate matter (PM) can cause adverse health effects via their ability to produce Reactive Oxygen Species (ROS). Water-Soluble Organic Compounds (WSOCs), a complex mixture of organic compounds which usually coexist with Transition Metals (TMs) in PM, have been found to contribute to ROS formation. However, the interaction between WSOCs and TMs and its effect on ROS generation are still unknown. In this study, we examined the ROS concentrations of V, Zn, Suwannee River Fulvic Acid (SRFA), Suwannee River Humic Acid (SRHA) and the mixtures of V/Zn and SRFA/SRHA by using a cell-free 2′,7′-Dichlorodihydrofluorescein (DCFH) assay. The results showed that V or Zn synergistically promoted ROS generated by SRFA, but had an antagonistic effect on ROS generated by SRHA. Fluorescence quenching experiments indicated that V and Zn were more prone to form stable complexes with aromatic humic acid-like component (C1) and fulvic acid-like component (C3) in SRFA and SRHA. Results suggested that the underlying mechanism involving the fulvic acid-like component in SRFA more tending to complex with TMs to facilitate ROS generation through π electron transfer. Our work showed that the complexing ability and complexing stability of atmospheric PM organics with metals could significantly affect ROS generation. It is recommended that the research deploying multiple analytical methods to quantify the impact of PM components on public health and environment is needed in the future.     

上海白龙港排污口附近潮滩沉积物中重金属总量及其化学形态分析

利用Tessier分级提取法依次提取了上海白龙港排污口附近潮滩沉积物中几种重金属元素的化学形态 ,结果表明 :Cu、Pb、Fe、Zn、Cr在沉积物中均以残渣态为主 ,Mn以碳酸盐结合态为主 ,占到总量的 5 0 %左右 ;秋季碳酸盐结合态重金属向铁锰氧化物结合态发生形态迁移与转化 ,在低潮滩沉积物中 ,碳酸盐结合态重金属发生分解以后 ,一部分向上覆水发生了迁移和扩散 ;Cu、Pb、Fe、Mn重金属元素之间具有良好的相关性 ,Zn、Cr在沉积物中也表现出相似的化学行为。     

SAF-化学絮凝-微滤膜组合工艺处理高浓度生活污水的试验研究

采用SAF-化学絮凝-微滤分离膜组合工艺对高浓度生活污水进行处理.SAF处理系统对污染物的去除效果良好,CODCr,BOD5,SS和NH4 -N的去除率分别为92%,93%,90%和98%.SAF生物处理系统的出水再经化学絮凝和微滤分离膜深度处理后,CODCr,BOD5,NH4 -N,PO43--P的浓度分别低于40 mg/L,10mg/L,4mg/L,0.3mg/L;浊度小于0.5NTU,色度小于10度.试验结果表明该组合工艺处理后的污水水质优良,可满足生活杂用和市政杂用.     

HBCOD-1型COD在线自动监测仪的应用

介绍了HBCOD-1型COD在线自动监测仪的测定原理、分析流程和性能特点。仪器采用重铬酸钾氧化水中有机物和还原性无机物，通过分光光度法测定水中化学耗氧量（COD值）。与国标方法进行线性回归校正后，仪器测定值与国标方法测得的CODCr，值具有较好的一致性。     

建立能够体现化工行业特点的行业排放标准初探

化工行业具有传统的工业类型和新兴产业交叉渗透的特点。现有的污染物排放标准因涵盖行业过多、细化内容不够、可操作性不强、行业特点不突出,故不太适应化工行业的发展,建立新的化工行业污染物排放标准势在必行。文章概要介绍了我国现有污染物排放标准,分析了美国、欧盟、日本、德国等一些国家和组织的排放标准,提议建立能够体现化工行业特点的行业排放标准,以达到淘汰落后工艺和促进清洁工艺的目的。     

重铬酸钾法测定化学需氧量的几点体会

重铬酸钾法是测定工业废水中化学需氧量的国家标准方法，通过大量的实验对CODCr的实验进行探索，提出几点体会，在CODCr的测定中有一定的实用性。